NAS offline or not found? Check the LEDs and storage pool
When the NAS disappears, read the front-panel LEDs and cable first, then check the storage pool in DSM / QTS.
Troubleshooting Steps
-
1
Look at the NAS front panel power, STATUS and LAN LEDs for unusual blinking.
-
2
Confirm the cable and switch port are fine, then ping the NAS IP.
-
3
Open DSM (Synology) or QTS (QNAP) and check if the storage pool is degraded.
-
4
Check whether a disk dropped from RAID and replace it to rebuild.
-
5
Confirm the SMB / AFP service is enabled and the firewall is not blocking it.
Common Causes
Loose cable or a failed LAN port.
A disk failure has degraded the RAID.
The NAS is mid update or reboot.
The file service (SMB) is off or the IP changed.
Advanced Checks
Enable email alerts so you can swap a disk early before rebuild fails.
Use smartctl to read the SMART health of each disk.
When to Call a Pro
If RAID is degraded and you are unsure about swapping disks, we can visit and rebuild safely.
Contact an EngineerStill stuck?
Our engineers can help right away — on-site or remote.